GENISYS PROTOCOL DRIVER DOWNLOAD

Section Application Parameter s 2. Four additional LEDs report when individual 8-bit groups of input data are addressed by the Enhanced Controller board 3. No field repairs on the Enhanced Controller should be attempted beyond those described in this section. Otherwise, go to step 9. Any failure that triggers the watchdog circuit is shown by these LEDs, including failure to reset properly. If the serial carrier on the Master port is to be tested, continue with step 2. Where applicable, limits for a given parameter are displayed.

Uploader:	Kegul
Date Added:	23 October 2015
File Size:	58.74 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	75387
Price:	Free* [*Free Regsitration Required]

Typically used to turn on data carrier at start of transmitted message, turn off carrier and end of this message. Inputs from the DC code line are interfaced through four additional opto-isolators. Inspect assembly as follows: Batesburg, SC 2.

Executive software covered by this manual include: Generic rules for constructing the assembly are as follows: These additional parameters are also controllable in the Application software. Remaining parameters displayed onPC include: These errors can be generated by a fault in the Executive software, a critical interrupt of the microprocessor or by a hardware problem. RXC only used when receiving serial data in protovol mode.

GENISYS SERIES 2000 - Ansaldo STS | Product Support

Alpha-numeric display goes dark. Refer to Section 2.

The PC should show: If S2 address for Slave port 1 is to be entered or changed, continue with step 2, otherwise go to step 4. Most but not all configuration operations can be performed using the on-board configuration process. Display shows same test modes as step 3. Reference Figures and N Carrier Modem Interface: It is not an isolated command that must be entered and exited separate from the operational commands. Protoclo SW1 as required to bring up SS on alpha-numeric display.

GENISYS SERIES - Ansaldo STS | Product Support |

A bus address decoding circuit on the board receives two groups of external inputs: After all desired parameters are entered, the user may write the current configuration into the field configuration EEPROM. However, interpretation of PC-derived test data and corrective actions are not provided. Place cable tie Item 14 through holes in bracket and tighten cable tie Ref.

Universal spare port not used The asynchronous 9-pin port on pdotocol PCB front edge is only used for on-site set-up and diagnostics. If S2 Slave port key-on delay is to be entered or changed, continue with step 8. The permament configuration is determined to be invalid. When desired carrier option is selected, press SW2 to enter option.

Analysis of board LED fault displays B.

Auto recall option, cutout time, communication failure time out, etc. Consult detailed application circuit diagrams for variations and additional details in these circuits.

Batesburg, SC 3. Check board LEDs Ref. Table lists pinouts. When valid indication start pulse value is entered, PC should display next parameter.

If Master port parity is to be entered or changed, continue with step